Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
GRE Tunnel Interface Configuration Mode Commands
keepalive ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
keepalive
This command configures various parameters for sending Keepalives to the remote end-point in GRE tunnel interface
configuration. By default sending keepalives is disabled.
configuration. By default sending keepalives is disabled.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Sets the sending of Keepalives with default parameters.
: 10 seconds
: 3 retries
Disables the keepalive and turns off the sending of Keepalives messages.
Default: 10
Specifies the time interval (in seconds) between two Keepalives sent to remote ends of GRE tunnel interface
configuration.
Specifies the time interval (in seconds) between two Keepalives sent to remote ends of GRE tunnel interface
configuration.
must be an integer from 5 through 3600.
Default: 3
Specifies number of retransmission of keepalives to remote node without getting any response before the
remote node is marked as dead/down.
Specifies number of retransmission of keepalives to remote node without getting any response before the
remote node is marked as dead/down.
must be an integer between 0 through 10.
Usage
Use this command to configure the parameters for sending Keepalives to the remote end-point of GRE
tunnel. It also configures the interval at which GRE Keepalives are sent on the interface and number of retries
without getting a response from the remote end-point before the tunnel is shutdown. By default, Keepalives
will not be sent.
tunnel. It also configures the interval at which GRE Keepalives are sent on the interface and number of retries
without getting a response from the remote end-point before the tunnel is shutdown. By default, Keepalives
will not be sent.
Example
The following command enables the keepalive and sets the other parameters to defaults:
The following command enables the keepalive and sets the other parameters to defaults: