Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
PDN Gateway Configuration
Configuring the System as a Standalone PMIP P-GW Supporting an eHRPD Network ▀
Cisco ASR 5000 Series Packet Data Network Gateway Administration Guide ▄
OL-22985-01
Required
Information
Information
Description
Physical port
number
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number
where the line card resides followed by the number of the physical connector on the card. For example, port
17/1 identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
where the line card resides followed by the number of the physical connector on the card. For example, port
17/1 identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP address
Used when configuring static IP routes from the management interface(s) to a specific network.
Security
administrator name
administrator name
The name or names of the security administrator with full rights to the system.
Security
administrator
password
administrator
password
Open or encrypted passwords can be used.
Remote access
type(s)
type(s)
The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
Required P-GW Context Configuration Information
The following table lists the information that is required to configure the P-GW context on a P-GW.
Table 14.
Required Information for P-GW Context Configuration
Required
Information
Information
Description
P-GW context
name
name
An identification string from 1 to 79 characters (alpha and/or numeric) by which the P-GW context will be
recognized by the system.
recognized by the system.
Accounting
policy name
policy name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy will be
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
S2a Interface Configuration (To/from HSGW)
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface will be
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
subnet
subnet
IPv6 addresses assigned to the interface.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
number
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
address
address
Used when configuring static IP routes from the interface(s) to a specific network.