Cisco Cisco Packet Data Gateway (PDG)
GTPC Overload Control Profile Configuration
Mode Commands
Mode Commands
Overload control enables a GTP-C entity becoming or being overloaded to gracefully reduce its incoming
signalling load by instructing its GTP-C peers to reduce sending traffic according to its available signalling
capacity to successfully process the traffic. A GTP-C entity is in overload when it operates over its signalling
capacity, which results in diminished performance (including impacts to handling of incoming and outgoing
traffic).
signalling load by instructing its GTP-C peers to reduce sending traffic according to its available signalling
capacity to successfully process the traffic. A GTP-C entity is in overload when it operates over its signalling
capacity, which results in diminished performance (including impacts to handling of incoming and outgoing
traffic).
This chapter describes the GTPC Overload Profile Configuration Mode Commands
Command Modes
Exec > Global Configuration > GTPC Overload Control Profile Configuration
configure > gtpc-overload-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-gtpc-overload-control-profile)#
Available commands or keywords/variables vary based on platform type, product version, and installed
license(s).
license(s).
Important
•
•
•
•
•
•
•
•
•
Command Line Interface Reference, Modes G - H, StarOS Release 19
1093