Cisco Cisco Packet Data Gateway (PDG)
header-type
Defines the size of the header frame for Frame Relay transmissions over a CLC or CLC2 channelized line
card. (ASR 5000 only)
card. (ASR 5000 only)
Product
SGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-card-
slot_number
)#
Syntax Description
header-type header_size [ -noconfirm ]
default header-type [ -noconfirm ]
default header-type [ -noconfirm ]
default
Resets the configuration to the default header size of 2-bytes.
header_size
Sets the size for the header frame. header_size must be either 2-bytes or 4-bytes.
-noconfirm
Executes the command without additional prompting for command confirmation.
Usage Guidelines
Use this command to set the size of the header frame for Frame Relay messages emanating from the line card.
The size (2-bytes or 4-bytes) determines the amount of information that can be transmitted in that first
information frame.
The size (2-bytes or 4-bytes) determines the amount of information that can be transmitted in that first
information frame.
Not supported on all platforms
Important
Examples
Set the header to the smallest size.
header-type 2-byte
header-type 2-byte
Command Line Interface Reference, Modes C - D, StarOS Release 19
312
Card Configuration Mode Commands
header-type