Cisco Cisco ASR 5000
ATM Port Configuration Mode Commands
▀ threshold tx-utilization
▄ Command Line Interface Reference, StarOS Release 18
1614
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
Therefore, to avoid redundant alarms, it is recommended that only the receive or transmit utilization threshold be
configured.
configured.
Alerts or alarms are triggered for transmit port utilization based on the following rules:
Enter condition: Actual percent utilization of a port for transmit data > High Threshold
Clear condition: Actual percent utilization of a port for transmit data < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command in the Global Configuration Mode Commands chapter of this
reference to configure the polling interval and the
threshold monitoring
command in this chapter to
enable thresholding for this value.
Example
The following command configures a transmit port high utilization threshold percent of
70
and a low
threshold of
50
for an system using the Alarm thresholding model:
threshold tx-utilization 70 clear 50