Cisco Cisco Packet Data Gateway (PDG)
Loopback Interface Configuration Mode Commands
▀ ip address
▄ Command Line Interface Reference, StarOS Release 18
7072
ip address
Specifies the primary and optional secondary IPv4 addresses and subnets for this interface.
Product
All
Privilege
Security Administrator, Administrator
Syntax
ip address ip_address { mask | /mask } [ secondary ip_address ] [ srp-activate ]
no ip address ip_address
no
Removes the IPv4 address from this interface.
ip_address{ mask | /mask
}
Configures the IPv4 address and mask for the interface.
ip_address
must be entered using IPv4 dotted-
decimal notation. IPv4 dotted-decimal or CIDR notation is accepted for the mask.
Important:
For IPv4 addresses, 31-bit subnet masks are supported per RFC 3021.
secondary
ip_address
Configures a secondary IPv4 address on the interface.
Important:
You must configure the primary IPv4 address before you will be allowed to configure a secondary
address.
srp-activate
Activates the IP address for Interchassis Session Recovery (ICSR). Enable this IPv4 address when the Service
Redundancy Protocol (SRP) determines that this chassis is ACTIVE. Requires an ICSR license on the chassis
to activate.
Redundancy Protocol (SRP) determines that this chassis is ACTIVE. Requires an ICSR license on the chassis
to activate.
Usage
The following command specifies the primary IP address and subnets for this interface.
Example
The following example configures an IPv4 address for this interface:
ip address 192.154.3.5/24