Cisco Cisco Packet Data Gateway (PDG)
Loopback Interface Configuration Mode Commands
ip ranged-address ▀
Command Line Interface Reference, StarOS Release 18 ▄
7073
ip ranged-address
Specifies an IPv4 address and subnet; all addresses in the subnet are local. Configures the range or group of IP address
for the loopback interface. This command enables support for multiple Enterprise HAs in one HA service.
for the loopback interface. This command enables support for multiple Enterprise HAs in one HA service.
Product
All
Privilege
Security Administrator, Administrator
Syntax
[ no ] ip ranged-address ip_address [ mask | /mask ]
no
Removes the IPv4 ranged address from this interface.
ip_address[ mask | /mask
]
Configures the IPv4 address and mask for the interface.
ip_address
must be entered using IPv4 dotted-
decimal notation. IPv4 CIDR notation is accepted for the mask.
Important:
This interface configuration is allowed only for IPv4 addresses and must be bound to the HA
Service.
Usage
This command provide Enterprise HA support on HA service for multiple enterprise nodes. Refer HA
Administration Guide for more information.
This IP address range configuration must meet the following criteria:
Administration Guide for more information.
This IP address range configuration must meet the following criteria:
The ranged address must be a primary address.
The ranged address must be unique across the interface configuration.
The ranged address must be unique across the context.
The IP address specified in the ranged address must not be part of any other interface.
The ranged-address can be a n SRP-activated address.
Example
The following example configures a ranged IPv4 address for this interface:
ip ranged-address 192.154.3.5/24