Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
switchover allow-all-data-traffic ▀
Command Line Interface Reference, StarOS Release 18 ▄
8499
switchover allow-all-data-traffic
Allows all data traffic (VoLTE and non-VoLTE) during switchover transition. This command overwrites the
switchover allow-volte-data-traffic command if enabled on a P-GW.
switchover allow-volte-data-traffic command if enabled on a P-GW.
Product
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
switchover allow-all-data-traffic
no switchover allow-all-data-traffic
no
Disables this feature. The default behavior is to not allow data traffic during switchover.
Usage
Use this command to allow all data traffic (VoLTE and non-VoLTE) during an ICSR switchover. This
feature reduces data traffic outage during the switchover.
feature reduces data traffic outage during the switchover.
Important:
This CLI command must be run on both the active and standby chassis to enable this feature.
All data traffic is allowed on the active chassis during flushing and internal auditing. The billing information
is reconciled in the background once the flush is complete.
is reconciled in the background once the flush is complete.
Example
The following command enables this feature:
switchover allow-all-data-traffic