Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
▀ switchover allow-volte-data-traffic
▄ Command Line Interface Reference, StarOS Release 18
8500
switchover allow-volte-data-traffic
Allows VoLTE data traffic during ICSR switchover transition.
Product
P-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
switchover allow-volte-data-traffic [ maintain-accounting ]
[ maintain-accounting ]
When enabled this option maintains accounting accuracy for VoLTE calls.VoLTE data is allowed on the
active chassis after VoLTE accounting statistics are flushed.
active chassis after VoLTE accounting statistics are flushed.
Usage
Use this command to allow VoLTE data traffic during ICSR switchover transition. VoLTE data traffic is
allowed on the active chassis during flushing and internal auditing. There may be some billing inaccuracy.
Non-VoLTE data traffic is allowed after flushing and the internal audit are completed.
This feature is superseded when the switchover allow-all-data- traffic command is enabled.
allowed on the active chassis during flushing and internal auditing. There may be some billing inaccuracy.
Non-VoLTE data traffic is allowed after flushing and the internal audit are completed.
This feature is superseded when the switchover allow-all-data- traffic command is enabled.
Example
The following command enables this feature:
switchover allow-volte-data-traffic maintain-accounting