Cisco Cisco Packet Data Gateway (PDG)

Seite von 128
Configuring the SaMOG Gateway   
▀  Configuring the System to Perform as a SaMOG Gateway 
 
 
▄  SaMOG Administration Guide, StarOS Release 18 
112 
   
   ip route ip_address[/mask ] next-hop ip_address interface_name1 vrf vrf_name 
   port ethernet port_number 
      no shutdown  
      ingress-mode 
      bind interface interface_name context_name 
      vlan vlan_number 
         ingress-mode 
         bind interface interface_name1 context_name 
         no shutdown 
         end 
config 
   context context_name 
      twan-profile twan_profile_name 
         ue-address dhcp 
         access-type client ipv4_address[/mask ] ip 
         access-type ip vrf vrf_name 
         radius ip vrf vrf_name 
         radius client ipv4_address[/mask ] key shared_secret_key disconnect-message 
dest-port 
port_number dictionary custom71 
         end 
Notes: 
 
Use the 
ip vrf forwarding
 command to associate a GRE tunnel with the VRF.  
 
Use the 
ingress-mode 
command to process UL user packets for L3IP access-type. 
 
Each TWAN Profile creates a “aaa group” in all AAAMgrs with the name 
samog_rad_grp_twan_profile_name
Configuring AAA 
Create the AAA group for DIAMETER authentication and then configure AAA accounting and authentication by 
applying the example configuration below. 
config 
   contextaaa_context_name