Cisco Cisco Packet Data Gateway (PDG)
Configuring the SaMOG Gateway
▀ Configuring the System to Perform as a SaMOG Gateway
▄ SaMOG Administration Guide, StarOS Release 18
112
ip route ip_address[/mask ] next-hop ip_address interface_name1 vrf vrf_name
port ethernet port_number
no shutdown
ingress-mode
bind interface interface_name context_name
vlan vlan_number
ingress-mode
bind interface interface_name1 context_name
no shutdown
end
config
context context_name
twan-profile twan_profile_name
ue-address dhcp
access-type client ipv4_address[/mask ] ip
access-type ip vrf vrf_name
radius ip vrf vrf_name
radius client ipv4_address[/mask ] key shared_secret_key disconnect-message
dest-port port_number dictionary custom71
dest-port port_number dictionary custom71
end
Notes:
Use the
ip vrf forwarding
command to associate a GRE tunnel with the VRF.
Use the
ingress-mode
command to process UL user packets for L3IP access-type.
Each TWAN Profile creates a “aaa group” in all AAAMgrs with the name
samog_rad_grp_twan_profile_name
.
Configuring AAA
Create the AAA group for DIAMETER authentication and then configure AAA accounting and authentication by
applying the example configuration below.
applying the example configuration below.
config
contextaaa_context_name