Cisco Cisco Packet Data Gateway (PDG)

Getting Started

Using the StarOS CLI for Initial Configuration ▀

VPC-VSM System Administration Guide, StarOS Release 19 ▄

interface_name is the name of the interface that you configured in step 7b.

Step i Exit the Ethernet Interface Configuration mode by entering the command:

[local]host_name(config-port-slot#/port#)# exit

[local]host_name(config)#

Important:

Refer below for instructions on configuring the vNIC management interface with a second

IP address.

Configuring the Management Interface with a Second IP Address

If necessary, you can configure a second IP address on the vNIC management interface.

Step 1

Enter the configuration mode by entering the following command at the prompt:

[local]host_name# configure

[local]host_name(config)#

Step 2

Enter the following to enter the context configuration mode:

[local]host_name(config)# context local

[local]host-name(config-ctx)#

Step 3

Enter the interface slot number and port number via the following command:

[local]host_name(config-ctx)# 1/1

[local]host_name(config-if-eth)#

Step 4

Enter the secondary IP address and subnet mask by entering the following command:

[local]host_name(config-if-eth)# { ip | ipv } address ipaddress subnet_mask
secondary

Step 5

Exit the configuration mode by entering the following command:

[local]host_name(config-if-eth)# end

Step 6

Confirm the interface ip addresses by entering the following command:

[local]host_name# show config context local

The CLI output should look similar to this example:

config

context local

interface interface_name