для Cisco Cisco Packet Data Gateway (PDG)
Getting Started
Using the StarOS CLI for Initial Configuration ▀
VPC-VSM System Administration Guide, StarOS Release 19 ▄
47
interface_name is the name of the interface that you configured in step 7b.
Step i Exit the Ethernet Interface Configuration mode by entering the command:
[local]host_name(config-port-slot#/port#)# exit
[local]host_name(config)#
Important:
Refer below for instructions on configuring the vNIC management interface with a second
IP address.
Configuring the Management Interface with a Second IP Address
If necessary, you can configure a second IP address on the vNIC management interface.
Step 1
Enter the configuration mode by entering the following command at the prompt:
[local]host_name# configure
[local]host_name(config)#
Step 2
Enter the following to enter the context configuration mode:
[local]host_name(config)# context local
[local]host-name(config-ctx)#
Step 3
Enter the interface slot number and port number via the following command:
[local]host_name(config-ctx)# 1/1
[local]host_name(config-if-eth)#
Step 4
Enter the secondary IP address and subnet mask by entering the following command:
[local]host_name(config-if-eth)# { ip | ipv } address ipaddress subnet_mask
secondary
secondary
Step 5
Exit the configuration mode by entering the following command:
[local]host_name(config-if-eth)# end
Step 6
Confirm the interface ip addresses by entering the following command:
[local]host_name# show config context local
The CLI output should look similar to this example:
config
context local
interface interface_name