Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis

Seite von 678
  IPSG Changes in Release 15.0 
IPSG Enhancements for September 30, 2013  ▀   
 
Cisco ASR 5x00 Release Change Reference  ▄  
 
   
275 
IPSG Enhancements for September 30, 2013 
IPSG Feature Changes as of September 30, 2013 
This section provides information on IPSG feature changes in release 15.0. 
Important:
  For more information regarding features in this section, refer to the IPSG Administration Guide for 
this release. 
New IPSG Features 
This section identifies new IPSG features available in release 15.0. 
Lawful Intercept Support for IPSG
 
The Lawful Intercept feature is now supported on IPSG. For more information, contact your Cisco representative. 
Support for Peer Selection at Diabase 
 
In the earlier Gx implementation, Diameter Policy Control Application has the limitation to mandatorily configure hosts 
as part of IMS Authorization service or associate a host template and select the hosts to be communicated for each 
subscriber session. Since the peer selection can occur at diabase, and the application need not select any hosts, this 
feature is introduced to remove the restrictions imposed in the application and allow diabase to pick the peers in a 
round-robin fashion. In addition, this feature addresses peer selection at diabase even when the hosts picked by 
application are not active. This change in behavior is controlled through the CLI command 
endpoint-peer-select
 
as the default behavior is to drop the call if the server discovery fails at application. 
When the peers are selected from endpoint, the output of CLI command 
show ims-authorization sessions 
full
 does not display the "Primary PCRF Server" and "Secondary PCRF Server" fields. 
CC-Time AVP in Gx for IPSG
 
IPSG now supports the CC-Time AVP to be parsed in the Granted Service Unit (GSU) message sent over Gx interface. 
This AVP support is required for time reporting based billing to subscribers. For more information on the Time 
Reporting over Gx (TRoGx) feature, see the Gx Interface Support appendix of the IPSG Administration Guide
Support for VLANS and Overlapping IP Addresses
 
Important:
  This is a customer-specific feature. For more information, please contact your Cisco account 
representative.  
This release introduces support for overlapping IP addresses for subscribers serviced by access networks on IPSG using 
VLAN on the Sn interface.  
Overlapping IP addresses can be set up by defining multiple interfaces on the Sn side and binding them to separate 
VLANs, while a single interface is setup to separate traffic using VPNv4 on the Si side. When IPSG receives a packet,