Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis
IPSG Changes in Release 15.0
▀ IPSG Enhancements for September 30, 2013
▄ Cisco ASR 5x00 Release Change Reference
276
the appropriate session is identified based on the combination of IP address and VLAN. This feature currently supports
configuration to a maximum of 500 VLANs.
configuration to a maximum of 500 VLANs.
Validate RADIUS Client IP
This feature enables the ipsgmgr to validate RADIUS accounting messages from different configured RADIUS client IP
address, and forward requests to the session manager. The client IPs are validated by default and can be disabled using
the CLI command.
address, and forward requests to the session manager. The client IPs are validated by default and can be disabled using
the CLI command.
Modified IPSG Features
This section identifies IPSG features modified in release 15.0.
None for this release.
IPSG Command Changes as of September 30, 2013
This section provides information on IPSG command changes in release 15.0.
Important:
For more information regarding commands in this section, refer to the Command Line Interface
Reference for this release.
New IPSG Commands
This section identifies new IPSG commands available in release 15.0.
overlapping-ip-address
This command allows you to enable or disable overlapping of IP addresses which enables multiple users to use the same
IP address.
IP address.
config
context context_name
ipsg-service service_name mode radius-server
{ default | no } overlapping-ip-address
end
endpoint-peer-select
This command is used to perform server selection at Diabase when the hosts could not be selected by application or
when the hosts selected by the IMS Authorization application is inactive. For example, host table is not configured in
IMSA service, host table is configured but not activated, none of the rows in prefix table match the subscriber, host
template is not associated with IMSA service, host template could not select the hosts.
when the hosts selected by the IMS Authorization application is inactive. For example, host table is not configured in
IMSA service, host table is configured but not activated, none of the rows in prefix table match the subscriber, host
template is not associated with IMSA service, host template could not select the hosts.
config
context context_name