Cisco Cisco Packet Data Gateway (PDG) Veröffentlichungshinweis
P-GW Changes in Release 15.0
P-GW Enhancements for October 31, 2014 ▀
Cisco ASR 5x00 Release Change Reference ▄
383
P-GW Enhancements for October 31, 2014
This section identifies all of the P-GW enhancements included in this release:
Feature Changes - new or modified features or behavior changes. For details, refer to the Packet Data Network
Gateway Administration Guide for this release.
Gateway Administration Guide for this release.
Command Changes - changes to any of the CLI command syntax. For details, refer to the ASR 5x00 Command Line
Interface Reference for this release.
Interface Reference for this release.
Performance Indicator Changes - new, modified, and deprecated bulk statistics, disconnect reasons, counters and/or
fields in new or modified schema and/or show command output. For details, refer to the ASR 5x00 Statistics and
Counters Reference for this release.
fields in new or modified schema and/or show command output. For details, refer to the ASR 5x00 Statistics and
Counters Reference for this release.
Important:
This release includes enhancements that are applicable to multiple products. The following lists the
various multi-product enhancements sections, some of which might include content applicable to your SGSN.
AAA Enhancements
CF Enhancements
ECS Enhancements
Firewall Enhancements
GTPP Enhancements
Lawful Intercept Enhancements
MVG Enhancements
NAT Enhancements
SNMP MIB Enhancements
System and Platform Enhancements
CSCui10427 - default behavior for vrf-multipath is to use the global multipath
Feature Changes
Default Behavior for vrf-multipath is to Use Global Multipath
Previous Behavior: There was an error where the multipath configured under “address-family ipv4 vrf <>” was never
being used. The multipath value under the router bgp level was being used instead.
being used. The multipath value under the router bgp level was being used instead.
New Behavior: If the multipath is configured under vrf mode, then this value is used for prefixes under vrf. If
multipath is not configured under vrf-mode, then the router bgp multipath values are used for prefixes in the vrf.
multipath is not configured under vrf-mode, then the router bgp multipath values are used for prefixes in the vrf.
Customer Impact: If the customer was not using any config under the vrf-mode then there is no difference. If the
customer was using the multipath value under the vrf-mode, then the difference is that this config will start taking affect.
customer was using the multipath value under the vrf-mode, then the difference is that this config will start taking affect.