Cisco Cisco Prime Network 3.8

 identifies bugs that were listed as open bugs in the Prime Network 3.8 release notes and have 

since been resolved. 

CSCtl87991

cefc FRU Inserted alarm is not shown in Prime Network Events

In gateway server high availability setups, the standby database might stop 
applying redo and thus not synchronize with the primary database

Adding or editing a user-defined VNE by software version without selecting a 
scheme results in a null-pointer exception

VNE enters and stays in Currently Unsynhronized state

Command Builder not working for CPT device

Interface table not modeled for bridges on Nexus 7000 device

Inside and Outside VRF details are not modeled for a NAT 44 instance

Importing images to the repository fails for C3750, C7200, C3560, and ME340X 
series devices

"Ticket is in use" error occurs after running Remove command on a ticket

No IS-IS Neighbor tab for Cisco 7600 devices

Independent VNE installer: checks if the driver was already updated

Cisco ANA 3.7.1 Upgrade: After upgrade, deleting old ANA user results in 
exception

Catalyst 4503 device is not modeled in GUI

Cisco ASR 9000 devices: OSPF processes do not show serial interfaces in GUI

Port 162 appears to be occupied when IP address contains “162”

VNEs reach Operational state before physical inventory is populated

Fix upgrade.pl warning for uninitialized value

Migration: anactl start halts after upgrade step fails

Pseudowire tunnel container is removed when all tunnels are removed

Soft Property command in debug takes too long

Yes or no questions during the embedded database installation accept incorrect 
input

Embedded database: Path for destination cannot contain underscore (_) or dash (-)

Discovery protocol disappears from NetworkVision physical inventory after a 
change

OSPFv3 Routing Neighbor Down syslog on Cisco IOS XR does not correlate to 
OSPF interface

VNE flapping due to time synchronization issue