Cisco Cisco StadiumVision Mobile Wartungshandbuch
© 2011 Cisco Systems, Inc. All rights reserved.
Page 41 of 94
Note: To see the detailed DMP Status, click the Status tab.
Figure 40.
Provisioned DMPs in the Control Panel
Preparing SV Director, the DHCP Server, and the DMP for
Auto Registration
Auto Registration
Perform the following steps to prepare SV Director, the DHCP Server and the DMP
for auto registration and auto provisioning.
for auto registration and auto provisioning.
1. Enable auto registration and auto provisioning in the SV Director Management
2. Setup the DHCP Server with options that enable the DMP to discover and
3. If not already installed, install auto registration-capable firmware on the DMP
(StadiumVision Release SE2.2.1 build 1932 or higher). This is typically done as
part of an upgrade from a previous SV Director release and upgrading DMP
firmware is not covered in this document.
part of an upgrade from a previous SV Director release and upgrading DMP
firmware is not covered in this document.
Note: As of this time, there are two versions of DMP 4310. One ships as a SV
specific version (DMP-4310G-SE-K9) and a generic version (DMP-4310G-52-K9).
The hardware is identical, but the firmware loaded at the factory is different. The
DMP-4310G-52-K9 ships with version 5.2 firmware and supports auto registration.
When a DMP-4310G-52-K9 also supports registration and when it registers with SV
Director it will be upgraded to the correct StadiumVision firmware version if
necessary.
specific version (DMP-4310G-SE-K9) and a generic version (DMP-4310G-52-K9).
The hardware is identical, but the firmware loaded at the factory is different. The
DMP-4310G-52-K9 ships with version 5.2 firmware and supports auto registration.
When a DMP-4310G-52-K9 also supports registration and when it registers with SV
Director it will be upgraded to the correct StadiumVision firmware version if
necessary.