Cisco Cisco Packet Data Gateway (PDG)

Seite von 158
C H A P T E R  
5
Monitoring the Service
This chapter provides information for monitoring service status and performance using the show commands
found in the Command Line Interface (CLI). These command have many related keywords that allow them
to provide useful information on all aspects of the system ranging from current software configuration through
call activity and status.
The selection of keywords described in this chapter is intended to provided the most useful and in-depth
information for monitoring the system. For additional information on these and other show command
keywords, refer to the Command Line Interface Reference.
In addition to the CLI, the system supports the sending of Simple Network Management Protocol (SNMP)
traps that indicate status and alarm conditions. Refer to the SNMP MIB Reference Guide for a detailed listing
of these traps.
Monitoring System Status and Performance
This section contains commands used to monitor the status of tasks, managers, applications and other software
components in the system. Output descriptions for most of the commands are located in the Counters and
Statistics Reference
.
Table 9: System Status and Performance Monitoring Commands
Enter this command:
To do this:
View HNB-GW Service Information
show hnbgw session all
View HNB-GW services running on chassis
show hnbgw session summary
View summary of HNB-GW sessions running on chassis
show hnbgw session full
View detailed information of HNB-GW sessions
Monitor HNB-GW Subscriber Session Information
HNB-GW Administration Guide, StarOS Release 19    
121