Cisco Cisco Firepower Management Center 2000
43-18
FireSIGHT System User Guide
Chapter 43 Configuring Active Scanning
Managing Scan Targets
Note that scans for scan targets containing a large number of hosts can take an extended period of time.
As a workaround, scan fewer hosts at a time.
As a workaround, scan fewer hosts at a time.
After you create a scan target, you can modify or delete it.
For more information, see the following sections:
•
•
•
Editing a Scan Target
License:
FireSIGHT
You can modify scan targets you created.
Tip
You might want to edit a remediation’s dynamic scan target if you do not want to use the remediation to
scan a specific IP address, but the IP address was added to the target because the host was involved in a
correlation policy violation that launched the remediation.
scan a specific IP address, but the IP address was added to the target because the host was involved in a
correlation policy violation that launched the remediation.
To edit an existing scan target:
Access:
Admin/Discovery Admin
Step 1
Select
Policies > Actions > Scanners
.
The Scanners page appears.
Step 2
On the toolbar, click
Targets
.
The Scan Target List page appears.
Step 3
Click
Edit
next to the scan target you want to edit.
The Scan Target page appears.
Step 4
Make modifications as necessary and click
Save
.
The scan target is updated.
Deleting a Scan Target
License:
FireSIGHT
Delete a scan target if you no longer want to scan the hosts listed in it.
To delete a scan target:
Access:
Admin/Discovery Admin