Samsung SMO-210TRP Benutzerhandbuch

5-3. After setting this position, adjust the Focus

Lever to get the picture into focus.

5-4. When the zoom and focus settings are finished,

rotate the Zoom and Focus Levers to fix the                              ...
lens imposition.

5-5. After the adjustment, put the lens hood onto the

camera body and rotate it in the locking direction
to connect it.

6. Setting the brightness (lris setting)

The lris is adjusted in the factory prior to shipping:
however, users may need to adjust the opening
and/or closing of the lris according to the position                           
of installation, and ambient light conditions.
Use the Level VR located on the back of the camera                       
to optimize conditions.

7. Selecting FL-MODE Switch.

This function key is used to switch the anti-flicker
function ON/OFF.
Flicker effect occumence (due to power frequency
differences) may be eliminated by turning this key
‘ON’.

8. After the camera lens has been adjusted, use the camera mount

bracket to the direction you want to monitor and then fasten it tight.

In case electroma gnelic waves affect SOC-320(P), please wind the core

ferrite at a proper point. (The core ferrite is contained in SOC-320P only.)

2) 12X Zoom lens High Band standard Camera (SOC-420P) 

1. Choose an installation site that can sufficiently support a minimum

of five times the net weight of the equipment to be installed

(approx. 800g).

2. Install the provided mounting bracket and then

connect one end of the cable to the rear of the
camera. When doing this, arrange the cable so
that it won’t get damaged or caught on anything.

3. Connect the other end of the cable to the monitor or other accessory

equipment.

4. Use the handle on the mounting bracket to direct the camera to the

area you want to monitor.

This output signal (DC17V, 300mA) that control external devices
when the AUX CONTROL key of the monitor or remote controller
is pressed.

CONNECTOR
One is for the camera-end of the cable, and the other is for the
monitor-end of the cable.

Eng-7

CORE-FERRITE

CABLE

8      ...      1

Pin No.

1

2

3

4

5

6

7

8

Pin Arrangement

DATA+

VIDEO_OUT

GND

DATA-

AUDIO_OUT

VDD

GND_V

CH_SEL

Pins indicated with ‘    ’ are not used.

8      ...      1

1

2

3

4

5

6

7

8

DATA+

VIDEO_OUT

GND

DATA-

AUDIO_OUT

VDD

GND_V

CH_SEL