Autotek autocad raster design 2010 Benutzerhandbuch

■

Enter e (End) to verify the endpoint of the vector line segment you
just created. A rubber-band line appears from the current start point.
Click to select a new endpoint.

■

Enter sw (Switch) to make the current endpoint the start point, and
the current start point the endpoint.

■

Enter t (Trim) to trim (shorten) the vector line segment you just created
by clicking an intersecting vector entity. See 

 (page 211).

■

Enter x (Extend) to lengthen the vector line segment you just created
by clicking an intersecting vector entity. See 

 (page 211).

5 Repeat step 3, or press Enter to exit the command.

When you select the Angle option of the Line tool, the following prompt is
displayed:

Enter new angle or [Match]<“XdX'X”>

NOTE ProdNameShort adjusts the angle about the start point.

Do one of the following:

■

To change the angle, enter a new angle.

■

To match the angle of an existing vector, enter m, then select the vector
line.

■

To use an angle from the Most Recently Used or Most Frequently Used list
(depending on your settings in the Raster Design Options dialog box),
right-click, then click a value on the shortcut menu.

When you select the Length option of the Line tool, the following prompt is
displayed:

Enter new length or [Match]<XXX>:

Do one of the following:

■

To change the length, enter a new length.

210 | Chapter 8   Converting Raster Entities to Vector