Autotek autocad raster design 2010 Benutzerhandbuch

1 For straight lines, click Image menu  ➤  Vectorization Tools  ➤  Line. Or

for polylines, Click Image  ➤  Vectorization Tools  ➤  Polyline..

The following prompt appears:

Specify one-pick point or [2P]:

NOTE When you use the one-pick method to select the raster entity,
ProdNameShort corrects the point you picked according to the current
drafting settings or rounding values. For more information, see 

 (page 205).

2 Do one of the following:

■

Select a raster line by clicking near the beginning of the line. The
endpoint nearest the point you select is considered the start point.

■

Enter 2p, then enter two points to define the raster line you are
vectorizing.

3 NOTE You can cancel the selection of a point by typing undo after you pick

the point.

4 Select another raster line using the one-pick method, or do one of the

following:

■

Enter 2p to select another raster line to vectorize using the multi-pick
selection method.

■

Enter a (Angle) to verify the angle of the vector line segment you just
created. See 

 (page 210).

■

Enter l (Length) to verify the length of the vector line segment you
just created. See 

 (page 210).

■

Enter u (Undo) to remove the last vector line segment you created.

If you used the one-pick method to select the raster line, the following
options are available:

■

Enter st (Start) to verify the start point of the vector line segment you
just created. A rubber-band line appears from the current endpoint.
Click to select a new start point.

Vectorizing Raster Lines and Polylines | 209