HP laserjet 3390, 3392 all-in-one Servicehandbuch
Pickup-and-feed assemblies
This section covers the major assemblies of the pickup-and-feed system: the transfer roller and the
registration assembly.
registration assembly.
For information about replacing the tray 2 pickup roller, see
.
For information about replacing the tray 2 or tray 3 separation pad, see
Transfer roller
NOTE
Make sure that the transfer roller needs to be replaced before you remove it. Excess
handling can cause additional damage.
1.
.
2.
Use needle-nose pliers to release the transfer roller tabs at the end of the roller, near the right side
of the all-in-one.
of the all-in-one.
CAUTION
Do not break the tabs and do not touch the roller.
Figure 5-82
Remove the transfer roller
3.
Lift up the end of the roller near the right side of the all-in-one, and then slide it toward the right
side of the all-in-one while pulling it out of the all-in-one.
side of the all-in-one while pulling it out of the all-in-one.
ENWW
Internal assemblies
171