HP lp145n Benutzerhandbuch
Paper Recommendations
69
5
Label Paper
OHP transparencies
Paper not supported by this printer
Avoid using the following paper as they are not supported by this printer.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
Printer setup
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [La-
bels]
for the bypass tray's paper type.
Printer driver setup
Click [Labels] in the [Paper type:] list.
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
side the bypass tray.
Duplex printing
Not possible
Additional cautions
Print speed is slightly slower compared to plain paper.
Printer setup
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [Trans-
parency]
for the bypass tray's paper type.
Printer driver setup
Click [OHP Transparency] in the [Paper type:] list.
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Number of sheets that can
be set
be set
• Bypass Tray: 20
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
side the bypass tray.
Duplex printing
Not possible
Additional cautions
• Print speed for OHP transparencies is slower than for plain pa-
per.
• Due to switching modes, the printer will be on standby for
thirty or forty seconds after the job was received.
• We recommend that you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.