Sony ipela snc-rz25p Benutzerhandbuch

Ot
her

s

Assigning the IP Address to the Camera Using ARP Commands

75

Do not turn off the camera until the camera is 
rebooted after uploading the homepage file.

The following page will appear after a while.

After displaying this page, the camera will be 
adjusted and rebooted automatically in two 
minutes.

Click Finish to exit the program.

This section explains how to assign an IP address to the 
camera using ARP (Address Resolution Protocol) 
commands without using the supplied setup program.

Enter the ARP commands within 5 minutes of the power 
of the camera being turned on.

Open the DOS window on the computer.

Enter the IP address and the MAC address of the 
camera to assign a new IP address, using the 
following ARP commands.

Example:

When the following line is displayed on the DOS 
window, hold down Ctrl and press C.

You will normally receive a reply after about 5 
repetitions of “Request time out.”

If you do not receive a reply, check the following:
– Did you enter the ARP commands within 5 minutes of 

the camera being turned on?
If not, turn off the camera and restart the operation.

– Is the NETWORK indicator on the camera flashing?

If the indicator goes off, the network connection has a 
problem.  Connect the network correctly.

– Did you enter the IP address previously used for 

another device?
Assign a new IP address to the camera.

– Do the computer and the camera have the same 

network address?  
If not, set the same network address on the computer 
and the camera.

arp -s <Camera's IP address> <Camera's MAC address>
ping -t <Camera's IP address>

arp -s 192.168.0.100  08-00-46-21-00-00
ping -t 192.168.0.100

Reply from 192.168.0.100:bytes=32 time...