Panasonic AJ-SPX800E Benutzerhandbuch

When the 

 BACK TALLY switch is set to [ON], the lamp

behaves in the same way as the front tally lamp at the
viewfinder. 

This switch controls the action of  the 

 back and 

 rear

tally lamps.

 Back and rear tally lamps enabled.

 Back and rear tally lamps disabled.

This lamp starts blinking or lights up if something unusual
occurs in the memory.

Use this button to control illumination of the display window.
Alternately pressing this button toggles illumination of the 
display window on or off. 

This window displays warnings, battery-remaining level,
sound volume, time data, and other information. 

When the 

 BACK TALLY switch is set on [ON], the rear

tally lamp behaves in the same way as the back tally lamp. 

Error Code Indication (for more information, see [7-3 
Warning System])

Battery-remaining level indication bar
For a battery with a digital indicator (percentage indication), if 
the remaining level of the battery is higher than 70%, all seven 
segments up to the “F” position are lit.
When the remaining level falls below 70%, the segments go out 
one-by-one for each drop of 10%. All seven segments can be set 
to light up when the battery-remaining balance is 100%. To do 
so select “100%” for the menu option BATT REMAIN FULL in the 
P2CARD> screen of the MAIN OPERATION page.

Audio channel level meter
When the MONITOR SELECT CH1/2 / CH3/4 switch is set to 
[CH1/2], the meter indicates 1 and 2 as the audio channel 
numbers, together with their audio levels. When the switch is set 
to [CH3/4], the meter indicates 3 and 4 as the audio channel 
numbers, together with their audio levels. 

Media-remaining space indication bar
The bar indicates the remaining free space on each P2 card, using a 
seven-segment display.
Each segment can represent either three or five minutes of remaining 
free space, depending on the value set through the menu option 
CARD REMAIN/

„. According to the set value, the segments 

disappear one-by-one. The menu option CARD REMAIN /

„ can be 

found in the <BATTERY/P2CARD> screen on the MAIN OPERATION 
page.   

Stays illuminated in LOOP REC mode. For information
about the LOOP REC mode, see [4-5 Setting Time Data].

Stays illuminated when the menu option USB is set to
“ON”.The menu option USB can be found in the
<SYSTEM MODE> screen on the SYSTEM SETTING
page. (To be supported in the near future.)

Stays illuminated when the optional slot is available. (To
be supported in the near future.)