Panasonic kx-tg8090fx Benutzerhandbuch

27

Up to 5 handsets can be registered to a single 
base unit.
Important:
L

The additional handset model recommended for 
use with this unit is noted on page 4. If other 
model handset is used, certain operations 
(handset settings, base unit settings, etc.) may 
not be available.

L

Additional handsets will give you the freedom to, 
for example, have an intercom call with another 
handset while a third handset is on an outside 
call.

Handsets can be registered to up to 4 base units, 
allowing you to add additional base units and 
extend the area in which your handset(s) can be 
used. You need to select the desired base unit to 
use the handset with (page 27).

The supplied handset and base unit are pre-
registered. If for some reason the handset is not 
registered to the base unit (for example, w flashes 
even when the handset is near the base unit), 
register the handset.

Press and hold {x} on the base unit for about 
5 seconds until a beep is heard.
L

If all registered handsets start ringing, press 
{x}

 to stop, then repeat this step.

L

After a beep is heard, the rest of this 
procedure must be completed within 1 
minute.

{

MENU} (right soft key) i r i {OK}

{^}

/{V}: “Registration” i {OK}

{^}

/{V}: “Register Handset” i {OK}

{^}

/{V}: Select a base unit number. i {OK}

L

This number is used by the handset as a 
reference only.

L

The registered base unit is indicated by “@”.

“Enter PIN” is displayed. Enter the base unit 
PIN (default: “0000”). i {OK}
L

If you forget your PIN, consult your nearest 
Panasonic service centre.

L

When the handset has been registered 
successfully, w will stop flashing. If the key 
tone is turned on (page 16), a confirmation 
tone will be heard.

When a specific base unit is selected, the handset 
will make and receive calls using that base unit 
only. If the handset is out of range of that base unit, 
no calls can be made.

{

MENU} (right soft key) i r i {OK}

{^}

/{V}: “Select Base” i {OK}

{^}

/{V}: Select the desired base unit. i 

{

OK}

L

The selected base unit is indicated by “t” 
located on the left of the item on the display.

L

The handset starts searching for the base 
unit.

A handset can cancel its own registration (or the 
registration of another handset) that is stored in the 
base unit. This will allow the base unit to “forget” 
the handset.

{

MENU} (right soft key) i r i {OK}

{^}

/{V}: “Registration” i {OK}

{^}

/{V}: “Deregistration” i {OK}

Enter the base unit PIN (default: “0000”). i 
{

OK}

L

If you forget your PIN, consult your nearest 
Panasonic service centre.

L

The numbers of all handsets registered to 
the base unit are displayed.

L

The handset you are using is indicated by 
“t” located on the left of the item on the 
display.

{^}

/{V}: Select the handset(s) you want to 

cancel. i {OK}

{

YES} i {i}

Note:
L

“Register!” is shown on the handset display 
when you cancel registration.

TG8070-8090FX(e-e).book  Page 27  Wednesday, August 1, 2007  9:26 AM