Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Panasonic
  4. wv-cm146
  5. Benutzerhandbuch

Panasonic wv-cm146 Benutzerhandbuch

Download
Seite von 22
-4-
u
Colour Control (COLOUR)
Turn this control clockwise to strengthen the picture
colour.
Turn this control counterclockwise to weaken the pic-
ture colour.
i
Colour Sub Control
o
Bright Control (BRIGHT)
Turn this control clockwise to increase the picture
brightness.
Turn this control counterclockwise to decrease the pic-
ture brightness.
!0
Bright Sub Control
!1
Contrast Control (CONTRAST)
Turn this control clockwise to increase the picture con-
trast.
Turn this control counterclockwise to decrease the pic-
ture contrast.
!2
Contrast Sub Control
!3
Picture Adjustment
Turn this control clockwise for a sharp picture.
Turn this control counterclockwise for a soft picture.
!4
Audio Control (AUDIO, MIN/MAX)
Turn this control clockwise to increase the audio level.
Turn this control counterclockwise to decrease the
audio level.
!5
Quad/Sequence, Set up Selection Switch
(QUAD/SEQUENCE, SET UP)
Press this switch to display the picture of quad or
sequential mode.
To display the SET UP MENU, press this switch more
than 2 seconds.
!6
Camera Selection Switch (1/5)/Up Switch (
D
)
!7
Camera Selection Switch (2/6)/Down Switch (
C
)
!8
Camera Selection Switch (3/7)/Left Switch (
A
)
!9
Camera Selection Switch (4/8)/Right Switch (
B
)
■
REAR VIEW
4
3
2
1
VP CAMERA
PLAY IN
OUT
TIMING SELECT
IN
ALARM
CONTROL
OUT
SPOT MONITOR CONTROL IN
4
3
2
1
RESET
RECOVER
FOCUS
STDBY ALL GND
ON
OFF
REC OUT
OUT
IN
AUDIO
MODE
5
6
7
8
GND
8
7
6
5
CAMERA
CAMERA INPUT
CAMERA POWER
@0
External Control Connection Terminals
ALARM CONTROL OUT
These terminals are used to supply the alarm con-
trol signal to external equipment such as Time
Lapse VTR or buzzer. When an intercom or alarm
sensor is connected to the spot monitor control
terminal, the alarm output signal is supplied from
the STAND-BY or ALL MODE terminal to the time
lapse VTR or buzzer.
RESET:
The alarm reset output signal is supplied to this
terminal for external equipment.
STAND BY-GND Connection:
The alarm output signal is supplied only when DIS-
PLAY MODE is at 
"
STAND BY.
"
ALL MODE-GND Connection:
The alarm output signal is supplied regardless of
display mode.
SPOT MONITOR CONTROL IN (1-8):
These terminals are used to receive the alarm con-
trol signal from intercom or alarm sensor.