FIC a440 Servicehandbuch

 

Installation and Upgrade 

FIC A440 Series Service Manual 

2-15

 

2.3.3  Memory Upgrade Procedure 

The notebook computer offers two 64-bit memory slot using 144-pin SODIMM (Small 
Outline Dual Inline Memory Module) at 32MB, 64MB, and 128MB PC-100 SDRAM. Two 
memory slots are found inside the memory compartment. The memory compartment is 
located on the underside of your computer inside the memory compartment. The notebook 
has no memory on-board so you should have at least one SODIMM module inserted.  
 
With two memory slots, you can have several combinations up to 256MB.   
 

 

 

n

 

DIMM door 

o

 

Int. modem / LAN door 

Using the Memory Slot inside the Memory Compartment 
Follow the steps below on how to upgrade the memory modules:  
 
1.  Make sure the system is powered off and that no peripheral devices are attached. 
 
2.  Turn the system over and locate the screw on the memory compartment. 

3.  Remove the screw and open the memory compartment. Locate the alignment notch on the 

module. 

 
4.  Locate the memory module socket. Align the notch with the notch in the socket connector 

and insert the module as follows: 

−  Hold the SODIMM at a 60-degree angle and align the SODIMM connector with 

the socket in the system. Push the connector into the socket. 

−  Press down on the edge of the SODIMM until the locking tabs on the sides snap 

into place, securing the module. 

 

5.  To remove a SODIMM, press the locking tabs away from the sides of the module until 

the module pops up. Then, remove the SODIMM. 

 
6.  Reassemble the notebook components as follows. 

−  Put the DIMM door back. 

−  Replace the screw and turn the system over.