FIC a440 Servicehandbuch

 

Outline of the A440 Series 

 

FIC A440 Series Service Manual 

1-23

 

Serial port A 

[Disabled] / [Auto] / 
[Enabled] 

Configure serial port A using options: 
 Disabled - No configuration, 
 Enabled - User configuration, 
 Auto - BIOS or OS configuration.  

Base I/O address 

[3F8 IRQ4] / [2F8 IRQ3] / 
[3E8 IRQ4] / [2E8 IRQ3] 

Set the base I/O address for serial port A. 

Parallel port 

[Disabled] / [Auto] / 
[Enabled] 

Configure parallel port using options: 
 Disabled - No configuration, 
 Enabled - User configuration, 
 Auto - BIOS or OS configuration.  

Mode 

[Uni-directional] / [ECP] / 
[Bi-directional] 

Set the mode for the parallel port using 
options. 

Base I/O address 

[378] / [278] / [3BC] 

Select the base I/O address for the 
parallel port when port is Enabled. 

DMA channel 

[DMA 0] / [DMA 1]  

Set the DMA channel for the ECP mode. 

Floppy disk 
controller 

[Disabled] / [Enabled] 

Configure the floppy disk controller using 
options: 
 Disabled - No configuration, 
 Enabled - User configuration 

 

If you disable a device in Setup, you cannot enable or assign it using the 
Windows (95 or 98) Device Manager. The device is not listed in the Windows 
device list. You need to select any setting other than “Disable” in Setup.