JVC dr-m10s Benutzerhandbuch

Filename [DR-M10SE_11Subsidiary.fm]

Masterpage:Left+

Page 110

February 12, 2004 5:31 pm

1. The desired programme cannot be 

recorded.

● The channel position does not 

correspond to that in the receiving area.

Set the correct channel position for the 
receiving broadcast. (

2. Recording and editing cannot be 

made.

● No disc or a disc not being compatible 

with the unit is loaded.

Load a recordable disc on the unit. 
(

● The disc loaded is not formatted.

Format the disc. (

● A finalised DVD-R disc is loaded.

Recording and editing cannot be made on 
finalised discs. (

recordable disc on the unit.

● The disc is full or does not have enough 

space for the programme to be recorded.

Clear unnecessary programmes on the 
disc or load a blank disc. (

3. Timer programming cannot be made.

● Date and time is not correct.

Set date and time correctly. (

4. Timer programming recording does not 

start.

● Power failure occurred before the timer 

programmed recording starts.

Check the timer programming. (

5. S

HOW

V

IEW

 Timer Programming cannot 

be made.

● Date and time set on the unit is not 

correct.

Set date and time correctly. (

● The channel position does not 

correspond to that in the receiving area.

Set the correct channel position for the 
receiving broadcast. (

6. Automatic Satellite Programming 

recording does not start.

● The satellite receiver is not connected 

properly to this unit.

Connect the satellite receiver to the L-2 
IN/DECODER connector properly. 
(

7. On the front display panel, “– –:– –” 

appears.

● Power failure occurred.

Set date and time correctly. (

8. “PROGRAM FULL” appears on the TV 

screen during timer programming.

● Eight programmes have already been 

timer programmed.

Clear unnecessary programmes on the 
unit, then try timer programming again. 
(

9. The disc space does not increase when 

recorded programmes are cleared.

● The PC’s data recorded on a DVD-RAM 

drive cannot be cleared on this unit.

Format the disc. (When the disc is soiled, 
wipe the disc with a soft dry cloth before 
formatting.) (

pg. 9, 106)

1. Malfunction occurs on the unit.

—

Press 1 to turn off the unit, press and 
hold 1, then press 8 for two seconds or 
more.

This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the 
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc, 
operate the unit as usual.

DR-M10SE_01.book  Page 110  Thursday, February 12, 2004  9:08 PM