Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Siemens
  4. TC63
  5. Benutzerhandbuch

Siemens TC63 Benutzerhandbuch

Download
Seite von 501
TC63 AT Command Set  
2.14 AT^SCFG
s
TC63_ATC_V00.490
Page 57 of 501
5/24/05
Confidential / Draft - Do not copy
 
AutoExec AT command String
This parameter specifies the AT command(s) to be launched automatically. Each AT command is executed in
the same way as if it were entered online, this means that command concatenation is possible if supported by
the given commands. If serial multiplex mode is activated (
) the first logical channel is used, i.e. CSD
calls (data or fax) could be set up. If the TC63 is busy on the serial channel command execution will be delayed
until ongoing action is finished. 
The first two characters of the automatically launched AT command shall be "at". 
Please refer to examples below.
Value will be saved while switching off the TC63 via AT commands (e.g. 
 or 
) and restored
on next power up. 
AutoExec Command Period
Parameter specifies the period after which 
 will be executed. Format is "hhh:mm:ss", where
characters indicate hours, minutes and seconds. This parameter applies to 
Value will be saved while switching off the TC63 via AT commands (e.g. 
 or 
) and restored
on next power up. 
000:00:05...240:00:00
AutoExec Command Period Left
This parameter shows the amount of time left until 
 will be executed. Format is "hhh:mm:ss",
where characters indicate hours, minutes and seconds. This parameter applies to 
=1 only.
Due to the internal activity and network signaling an execution delay of several seconds may occur for the overall
procedure.
000:00:00...240:00:00
AutoExec Command Status
This parameter is part of the Autoexec URC which is presented when a scheduled Autoexec activity is being
performed.
“1“
The value 1 indicates that the Autoexec activity specified with 
 is currently executed. 
Bit 
Mask
hex
 
Mask
dec
 
Control 
D
0
 
D
1
 
0x00 
0x01 
0x02 
0x03 
0 
1 
2 
3 
00: Ignore ongoing calls 
01: Wait until all calls have ended 
10: Dismiss any ongoing call 
11: RFU 
D
2
0x04
4
0: One shot action 
1: Periodic action (for "AutoExec/Period" only) 
D
3
 
0x08
8
RFU
D
4
 
0x10
16
RFU
D
5
 
0x20
32
RFU
D
6
 
0x40
64
RFU
D
7
 
0x80
128
RFU
<AutoExecATC>
(str)(+CSCS)
<AutoExecPeriod>
(str)(+CSCS)
<AutoExecPeriodTimeLeft>
(str)(+CSCS)
<AutoExecState>
(str)(+CSCS)