AstroStart 803u Benutzerhandbuch

9 

Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted. 
Note:  When the first code learning command is sent, all the old codes are cleared out. Therefore if you want to add a new 
remote, all the old ones must be reprogrammed as well. 
One or more remote transmitters can be added. To do this, programming is accessed as follows: 

 

Open hood 

 

Insert key in the ignition and turn to the RUN position 

 

Apply the brakes once 

 

You now have 10 seconds to turn the key from RUN to the STOP position 3 times. 

 

If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then 
proceed to the next step. 

 

Press any button on the new remote control. When access code of new remote control is memorized, the 
control module will confirm with flashing parking lights (1 flash). 

 

Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes). 

 

Apply the brakes. 

New remote(s) is (are) now added to the system. 

In order to maintain a high safety standard, proceed with the following checks every month. 

 

• 

Remote start your vehicle. 

• 

Open hood. 

 

Engine should stop as soon as hood is opened. 
If engine does not stop immediately, turn main switch to OFF position and leave it off until situation is rectified. Contact 
your service center. 

If key must be in ignition for gearshift to be moved out of P, your vehicle is safe as long as keys are kept away from children. 
If, on the other hand, gearshift can be put in gear without the key being in the ignition, proceed with this simple check. 

• 

Put gearshift in gear (D). 

• 

Remain in the vehicle and be ready to apply brakes. 

• 

Start vehicle with remote starter. 

• 

Repeat these steps with gearshift in every position other than Park and Neutral. 

If starter reacts within 90 seconds (which would be abnormal), turn main switch to OFF position and leave it off until 
situation is rectified. Contact your service center. 

• 

With gearshift in P, start vehicle with remote starter. 

• 

Remain in vehicle and be ready to apply brakes. 

• 

Without applying brakes, move gearshift out of P. 

 
If, without applying brakes, engine does not stop immediately (which would be abnormal), turn main switch to OFF position 
and leave it off until situation is rectified. Contact your service center.