AstroStart 803u Benutzerhandbuch

10 

Make sure the parking brake is operational, i.e. it has the capability of immobilizing the vehicle.  
If the parking brake cannot stop the wheels from turning, which is not safe, place the main switch in "OFF" position until the 
situation is rectified.  

1.  Carry out the safety sequence, then remote start the engine to confirm the safety sequence is valid.  

Make sure not to apply the brakes.  

2. 

Release the parking brake.  

The engine must stop immediately upon releasing the parking brake. If the engine does not stop, which is not safe, place the 
main switch in "OFF" position until the situation is rectified. Consult your service center. 

Make sure that the opening of each door (open one by one) will break safety sequence.  

1. 

Carry out the safety sequence, then remote start the engine to confirm the safety sequence is valid. 

2. 

Stop the engine using the remote control. Make sure you do not apply the brakes and that the parking brake 
remains applied until step 4.  

3. 

Open then close only one door once the engine has stopped.  

4. 

Try to start the engine using the remote control.  

The engine should not be able to be remote started. 
Repeat this test for every door of the vehicle (including hatchback if applicable).  
If the vehicle is equipped with fold-down rear seat backrests, the trunk has to be considered as a door since it is an opening 
that can give access to the passenger compartment. It must therefore be included in the safety sequence. 
If the engine starts, which is not safe, place the main switch in "OFF" position until the situation is rectified. Consult your 
service center. 

If you have to replace or boost your battery for any reason, turn main switch to OFF position and leave it OFF until battery 
is replaced or fully charged.