Epson LX-300+II Benutzerhandbuch
22
Paper Handling
8.
Slide the left sprocket so its pins are aligned with the holes in the
paper and push the blue lock lever to lock the sprocket in place.
Then slide the right sprocket to match the width of your paper, but
do not lock it. Move the paper supports midway between the two
sprockets.
paper and push the blue lock lever to lock the sprocket in place.
Then slide the right sprocket to match the width of your paper, but
do not lock it. Move the paper supports midway between the two
sprockets.
9.
Make sure your paper has a clean, straight leading edge. Open the
sprocket covers. Fit the first holes of the paper over the sprocket pins
and then close the sprocket covers. Slide the right sprocket to
remove any slack in the paper and then lock it in place.
sprocket covers. Fit the first holes of the paper over the sprocket pins
and then close the sprocket covers. Slide the right sprocket to
remove any slack in the paper and then lock it in place.
Note:
Remove any remaining slack by gently pulling the paper from the back.
Remove any remaining slack by gently pulling the paper from the back.
10. To separate the incoming paper from the printed paper, attach the
paper guide. Hold it horizontally and fit its notches over the
printer’s mounting posts. Then slide the paper guide toward the
back of the printer until you feel it click.
printer’s mounting posts. Then slide the paper guide toward the
back of the printer until you feel it click.
11. Turn the paper feed knob to adjust the paper position. The
perforation between pages should be just above the print head.
12. Replace the printer cover but leave it open.