Epson FX-890 Benutzerhandbuch
Paper Handling
31
R
Using the Micro Adjust Function
The Micro Adjust function allows you to move the paper forward or
backward in 1/216-inch (0.118 mm) increments to adjust the tear-off and
top-of-form positions.
backward in 1/216-inch (0.118 mm) increments to adjust the tear-off and
top-of-form positions.
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge, you can
use the Micro Adjust function to move the perforation to the tear-off
position, as described below. Your tear-off position setting remains in
effect until you change it, even if you turn off the printer.
use the Micro Adjust function to move the perforation to the tear-off
position, as described below. Your tear-off position setting remains in
effect until you change it, even if you turn off the printer.
c
Caution:
Never use the knob to adjust the tear-off position; this may damage the
printer or cause it to lose the tear-off position.
Never use the knob to adjust the tear-off position; this may damage the
printer or cause it to lose the tear-off position.
1.
You may need to press
the
the
Tear Off/Bin
button to
advance the paper to the
tear-off position. Make
sure the Tear Off/Bin
light is flashing (the paper
is at the current tear-off
position).
tear-off position. Make
sure the Tear Off/Bin
light is flashing (the paper
is at the current tear-off
position).
2.
Hold down the
Pause
button for about three
seconds. The Pause light
begins flashing and the
printer enters the Micro Adjust mode.
seconds. The Pause light
begins flashing and the
printer enters the Micro Adjust mode.