Epson 4012033-00 XXX Benutzerhandbuch
Installing and Setting up the Software
1-5
R4C5700
Rev. C
Rev. C
A5 size
INSTALL.FM
4/6/01
Pass 0
R
Proof Sign-off:
K. Pipa
K. Pipa
_______
M. Fujimori
_______
R. Thomson
_______
1
c
Caution:
Be sure to position the cable correctly before
inserting it into the interface connector.
Otherwise, the cable and/or connector may be
damaged.
Be sure to position the cable correctly before
inserting it into the interface connector.
Otherwise, the cable and/or connector may be
damaged.
4.
Set the camera’s dial switch to
and turn the
camera on (for PhotoPC 3000Z), or turn the
camera’s dial switch to
camera’s dial switch to
(for PhotoPC 850Z and
800). Then turn on the computer.
c
Caution:
Keep your camera and computer away from potential
sources of electromagnetic interference, such as
loudspeakers or base units of cordless telephones.
Keep your camera and computer away from potential
sources of electromagnetic interference, such as
loudspeakers or base units of cordless telephones.
Connecting to a Macintosh
You can connect the camera to a Macintosh using a
Macintosh serial cable. Follow the steps below.
Macintosh serial cable. Follow the steps below.
Note:
❏
❏
Make sure that AppleTalk is inactive for the port that
you use to connect your camera. Otherwise, the
computer may not recognize your camera.
you use to connect your camera. Otherwise, the
computer may not recognize your camera.
❏
To connect to a Macintosh using a USB cable, see
“Using the USB cable” on page 1-2.
“Using the USB cable” on page 1-2.
1.
Make sure that the camera and your computer are
turned off.
turned off.
2.
Plug the connector on the serial cable into the
modem or the printer port on your computer.
modem or the printer port on your computer.
Macintosh serial cable