Trimble Outdoors 58052-00 Benutzerhandbuch
A TRIMBLE STANDARD INTERFACE PROTOCOL (TSIP)
1 6 6 Copernicus GPS Receiver
Command Packet 0x8E-17 - Request Last Position or Auto-Report Position
in UTM Single Precision Format
in UTM Single Precision Format
This packet requests Packet 0x8F-17 or marks it for automatic output. If only the first
byte (packet sub-code 0x17) is sent, an 0x8F-17 report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in the table below.
To retain the auto-report setting for this packet, first set the setting accordingly and
then save to non-volatile memory by issuing the packet 0x8E-26.
byte (packet sub-code 0x17) is sent, an 0x8F-17 report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in the table below.
To retain the auto-report setting for this packet, first set the setting accordingly and
then save to non-volatile memory by issuing the packet 0x8E-26.
Table A.58
Command Packet 0x8E-17
Command Packet 8E-18 - Request Last Position or Auto Report Position in
UTM Double Precision Format
UTM Double Precision Format
This packet requests Packet 0x8F-18 or marks it for automatic output. If only the first
byte (packet sub-code 0x18) is sent, an 0x8F-18 report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in below. To retain
the auto-report setting for this packet, first set the setting accordingly and then save to
non-volatile memory by issuing the packet 0x8E-26.
byte (packet sub-code 0x18) is sent, an 0x8F-18 report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in below. To retain
the auto-report setting for this packet, first set the setting accordingly and then save to
non-volatile memory by issuing the packet 0x8E-26.
Table A.59
Command Packet 8E-18
Byte
Item
Type
Value
Definition
0
Packet sub-code
UINT8
0x17
Packet sub-code
1
Mark for auto-
report
report
UINT8
0,1
0=do not mark for auto-
report
1=mark for auto-report
report
1=mark for auto-report
Byte
Item
Type
Value
Definition
0
Packet sub-code
UINT8
0x18
Packet sub-code
1
Mark for auto-
report
report
UINT8
0,1
0=do not mark for auto-
report
1=mark for auto-report
report
1=mark for auto-report