Trimble Outdoors 58052-00 Benutzerhandbuch
Copernicus GPS Receiver 1 6 7
TRIMBLE STANDARD INTERFACE PROTOCOL (TSIP) A
Command Packet 0x8E-20 - Request Last Fix with Extra Information
This packet requests Packet
0x
8F-20 or marks it for automatic output. If only the first
byte (20) is sent, an
0x
8F-20 report containing the last available fix will be sent
immediately. If two bytes are sent, the packet is marked/unmarked for auto report
according to the value of the second byte as shown in below.
according to the value of the second byte as shown in below.
0x
37 can also be used
for requesting
0x
8F-20 if the
0x
8F-20 is scheduled for auto output.
Note – Auto-report requires that superpacket output is enabled. Refer to Command
Packet 35.
Packet 35.
Command Packet 0x8E-26 - Non-Volatile Memory Storage
The
0x
8E-26 command is issued with no data to cause the current settings to be saved
to non-volatile memory. The
0x
8F-26 report is generated after the values have been
saved.
Command Packet 0x8E-2A - Request Fix and Channel Tracking Info, Type 1
This packet requests Packet 0x8F-2A or marks it for automatic output. If only the first
byte (packet sub-code 0x2A) is sent, an 0x8F-2A report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in below.
byte (packet sub-code 0x2A) is sent, an 0x8F-2A report containing the last available
data will be sent immediately. If two bytes are sent, the packet is marked/unmarked
for auto report according to the value of the second byte as shown in below.
To retain the auto-report setting for this packet, first set the setting accordingly and
then save to non-volatile memory by issuing the packet 0x8E-26.
then save to non-volatile memory by issuing the packet 0x8E-26.
Table A.62
Command Packet 0x8E-2A
Table A.60
Command Packet 0x8E-20 Field Descriptions
Byte
Item
Type
Definition
0
Sub-packet id
UINT8
0x20
1
Mark for Auto-report (See Packet
35 byte 0 bit 5)
35 byte 0 bit 5)
UINT8
0 = do not auto-
report
1 = mark for auto-
report
report
1 = mark for auto-
report
Table A.61
Command Packet 0x8E-26 Definitions
Byte #
Item
Type
Value
Definition
0
Subcode
UINT8
0x26
Save Settings
Byte
Item
Type
Value
Definition
0
Packet sub-code
UINT8
0x2A
Packet sub-code
1
Mark for Auto-
report
report
UINT8
0,1
0 = do not auto-report
1 = mark for auto-report