Trimble Outdoors 58052-00 Benutzerhandbuch
Copernicus GPS Receiver 6 3
APPLICATION CIRCUITS 5
Figure 5.2 Passive antenna - HW Activated Standby Mode Available
Following is a description of the schematic:
•
Passive Antenna is used. The Copernicus GPS Receiver has an on-board LNA
and an Automatic Gain Control circuit.
and an Automatic Gain Control circuit.
•
The Pin LNA_XEN is not necessary and not connected.
•
There is no HW reset ability through the pin XRESET, since XRESET pin is
tied High to VCC.
tied High to VCC.
•
HW initiated Standby Mode through the Pin XSTANDBY is possible, since
XSTANDBY pin is not tied High to VCC. The software serial command to
Standby Mode can still be used as a second method to force the module into
Standby Mode.
XSTANDBY pin is not tied High to VCC. The software serial command to
Standby Mode can still be used as a second method to force the module into
Standby Mode.
•
There is no separate power for STANDBY power.
•
One serial port is utilized.
•