Ariens sno-thro 932105 - 8526 , 932506 - 8526 Benutzerhandbuch

GB - 19

IMPORTANT: Wipe each fitting clean before 
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to 
get on friction disc, friction plate or belts.
NOTE: Apply Stens Mix Hi-Temp Grease or 
equivalent to the lubrication fittings. See 
Service Parts.
Sno-Thro should be lubricated (Figure 11) at 
beginning of season or every 25 operating 
hours.

NOTE: To grease auger shaft, remove shear 
bolt nuts, and shear bolts. Turn auger on shaft 
while applying grease at zerk fittings. Replace 
shear bolt per instructions in Service and 
Adjustments.

Deflector must stay in selected position while 
throwing snow.
If deflector does not stay in set position: 

1. Tighten nut beneath the control panel to 

increase friction on pressure flange 
(Figure 12).

If deflector does not follow full range of travel:

1. Push deflector remote all the way 

forward.

2. Loosen adjusting nuts on cable support 

bracket.

3. To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4. To adjust deflector higher: 

Slide cable up. Tighten top nut.

5. Check travel and repeat adjustment as 

necessary.

If chute does not stay in position while 
operating, tighten nut on carriage bolt at pivot 
point to increase tension on spring (Figure 13).

Smooth and easy rotation of properly 
lubricated chute with crank is obtained by 
adjusting pinion and chute gear teeth so they 
mesh together.

OS1374

OS1731

Figure 11

Grease

Oil

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.