Snapper 11305 Benutzerhandbuch

 

 

IMPORTANT: Standing in the operator’s position, the left 
handle bar lever is for wheel drive engagement and 
disengagement. The right handle bar lever is for 
auger/impeller engagement and disengagement. Hold both 
levers down to handle bar for engagement and release 
levers for disengagement. When both levers are pressed 
down to the handle bar at the same time, the operator can 
release the right hand lever and the right lever will remain 
engaged as long as the left hand lever is held down to 
handle bar. Release the left hand lever and both levers will 
disengage. 
 

1.  Hold the wheel drive control lever down against the 
handle. See Figure 4.9. 

2.  Check position of the cam lock. It must align with 
the adjusting line located on the cam lock bracket. 
3. To adjust, loosen the nuts on the cable guide 
support bracket and move the bracket in or out until 
the cam lock aligns with the adjusting line. Retighten 
nuts. 
4. Hold the wheel drive control lever down to the 
handle bar, at the same time press the auger/impeller 
control lever down to the handle bar and hold in 
position. 
5.  Check the position of the cable ferrule in relation to 
the cam lock. The ferrule must be located 1/16” (.060) 
above the hook of the cam lock. To adjust, loosen the 
three nuts that secure the cam lock bracket. Slide 
bracket up or down until correct measurement is 
achieved. Retighten nuts securely. See Figure 4.9.