Snapper 11305 Benutzerhandbuch

 

 

PROBLEM 

PROBABLE CAUSE 

CORRECTIVE ACTION 

Engine Will Not Start   1. Fuel tank empty. 

1. Fill fuel tank with fresh fuel or fuel/oil mix. 

Using Recoil Starter 

2. Engine needs choking and priming. 

2. Move choke control to “CHOKE” position. Push 

primer bulb three times. 

 

3. Spark plug wire disconnected. 

3. Place spark plug wire onto spark plug. 

 

4. Fuel shut off valve closed. 

4. Move fuel shut off valve to the on position. 

Using Electric Starter 

1. Power extension cord not plugged into machine or    

120 Volt outlet for U.S.A. or 230 Volt for Europe. 

1. Plug power extension cord into machine & into 120 

Volt outlet for U.S.A. or 230 Volt for Europe.. 

 

2. Power extension cord damaged. 

2. Discard damaged power extension cord 

 

3. Starter switch damaged or faulty. 

3. Replace starter switch. 

Engine Stalls or Stops  1. Water, debris or stale fuel in fuel system. 

1. Drain and clean fuel system. 

After Running 

2. Choke control in the “CHOKE” position. 

2. Move choke control to “OFF” position. 

 

3. Fuel tank empty. 

3. Fill with fuel to proper level. 

 

4. Air intake clogged with snow or debris. 

4. Unclog air intake. 

 

5. Spark plug defective or gap set improperly. 

5. Service spark plug. 

Engine Loses Power  1. Engine lubrication oil level is low. 

1. Add oil to the engine to full level. 

 

2. Spark plug faulty. 

2. Service spark plug. 

 

3. Water, debris or stale fuel in fuel system. 

3. Drain and clean fuel system. 

Excessive Vibration 

1. Damaged, out of balance or bent auger. 

1. Service auger. 

 

2. Loose engine or auger/impeller components. 

2. Service and tighten loose components. 

 

3. Bent or loose Idler pulley 

3. Tighten or replace pulley. 

 

4. Cracked, severed or frayed belt 

4. Replace belt. 

1. Clogged discharge chute. 

1. Stop engine and unclog discharge chute. 

2. Damaged or bent auger/impeller or components. 

2. Service auger/impeller or components. 

3. Cracked, severed or frayed belt. 

3. Replace belt. 

4. Belt tension out of adjustment. 

4. Adjust belt tension. 

5. Insufficient lubrication in auger bearings. 

5. Lubricate all bearings as specified in manuals. 

Replace Engine 

Manual. 

Check Oil Level 

Engine Manual. 

Initial Oil Change 

Engine Manual. 

Periodic Oil Change 

Engine Manual 

Clean or Replace 

Engine Manual. 

Clean Shroud & Fins 

Engine Manual  

Check For Adjustment, 
Wear and Tension 

Page 13-15 

Check For Damage & 
Lubrication 

Page 11 

Check Air Pressure 

Page 6