Epson professional series ii Benutzerhandbuch

Alternatively, you can purchase your own video interface cable

and connect it to the monitor’s BNC connectors. See the BNC
connector signals table on page 54 to determine which video
interface cable(s) and BNC connectors to use with your system.

If your computer or video adapter card does not have a VGA
connector, you cannot use the video interface cable that comes

with the monitor. Determine the sync requirements of your
video controller, see the BNC connector signals table on
page 54, if necessary, and purchase the appropriate interface

cable(s). Consult your dealer if you need help. Then connect the
interface cable(s) to the appropriate connector(s).

Before you connect the monitor to your computer, you need to
make sure your computer and/or video adapter card is set up

for use with the monitor. If necessary, install an appropriate
video adapter card in your computer and set any DIP switches
or jumpers on the card to match the monitor. You may also

need to change jumper settings inside the computer. See your

computer and/or video adapter card manual for instructions.

If you want to connect two or more monitors to one video
controller, see page 10 for instructions.

Follow these steps to connect the monitor to your computer:

1. Before you connect any cables, make sure the monitor,

computer, and all other peripheral devices are turned off.
The monitor is off when the power button on the left side of

the control panel extends out from the panel, as shown in
the following illustration.