Epson 10+ Benutzerhandbuch

Clean the air filter on the bottom of the projector after every 100 hours of use. If it’s not 
cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can 
cause overheating and damage the projector.

1. Turn off the projector and wait for the P power light to stop flashing.

2. Unplug the power cord and disconnect any cables.

3. Turn the projector over. Then use a small vacuum 

cleaner designed for computers and other office 
equipment to clean the filter, as shown. If you don’t have 
one, gently clean the filter using a very soft brush (such 
as an artist’s camel-hair brush).

If the dirt is difficult to remove or the filter is broken, 
replace it. Contact your dealer or call Epson at (800) 
873-7766 and ask for part number 

V13H134A04

. In 

Canada, call (800) 463-7766 for dealer referral.

4. If you need to replace the filter, press the tab in and lift the 

cover up.

5. Remove the old filter and replace it with a new one.

6. To replace the cover, insert the tabs and press down until the 

cover clicks into place.