Epson 10+ Benutzerhandbuch

High-speed cooling is in process. If the projector gets too hot again, projection stops 
automatically. Make sure there is plenty of space around and under the projector for 
ventilation. Clean or replace the air filter if necessary. See page 27 for details.

The projector is too hot, which turns off the lamp automatically. Let it cool for five minutes, 
then turn it back on. Make sure there is plenty of space around and under the projector for 
ventilation. Also, clean or replace the filter if necessary. See page 27.

There’s a problem with the lamp. First check the Info menu to see if you need to replace the 
lamp (see page 23). If that’s not the problem, turn off the projector. When the P power light 
stops flashing, unplug the projector. Then take the lamp out to make sure it’s not broken. 

Warning: Let the lamp cool before taking it out. If the lamp is broken, handle the shards 
carefully to avoid injury. If your projector is mounted on the ceiling, take it down before 
attempting to remove the lamp.

■

The lamp cover may be loose or off. Make sure it’s securely fastened. See page 29.

■

There is an internal problem. Turn off the projector and, when the P power light stops 
flashing, unplug it. Contact your dealer.

■

Check that the P power light is green, not flashing, and the lens cover is off. If you’ve just 
turned the projector off, let it cool down for a couple of minutes.

■

The projector may be in standby (or sleep) mode. If the P power light is orange, press the 
P

 

Power

 button to turn the projector on. 

■

Press the 

A/V Mute

 button on the remote control to make sure the picture hasn’t been 

turned off temporarily.