Lennox 32fs Benutzerhandbuch

CLEANING AND MAINTENANCE SCHEDULE (CONTINUED)

In addition to the regular maintenance procedures described below, the “Installation and Operation Manual” out-

lines yearly service that should be performed by a qualified technician.

UltraGrate™

Ash Slide

Ash Pan

Additional Yearly

Maintenance*

1 - 7 Days*

1 - 2 Weeks*

2 Days - 2 Weeks*

*Burning fuel with a high ash content or an improperly adjusted damper may require more frequent cleaning and stove maintenance.

IMPORTANT NOTE:

BURNING POOR QUALITY FUEL WILL SIGNIFICANTLY INCREASE THE FREQUENCY OF REQUIRED CLEANING.

FAILURE TO PROPERLY CLEAN AND MAINTAIN YOUR STOVE AS INDICATED IN THE MANUAL CAN RESULT IN A

STOVE THAT IS UNSAFE TO OPERATE.

The UltraGrate should be checked

for clinkers prior to operating

the stove. Any non-combustible

material blocking the UltraGrate

should be emptied into the

firebox.

The ash slide pulls out allowing

you to “drop” any accumulated

ash from the firebox to the ash

pan.

The ash pan serves as a

receptacle to hold ash that has

accumulated in the firebox

and embers that drop from the

UltraGrate. Refer to the manual

for proper ash disposal.

Hot! Do not touch! The glass and surface of this appliance will

be hot during operation and will retain heat for a while after

shutting off the appliance. Severe burns may result.

Carefully supervise children in the same room as appliance.

Lennox pellet-burning appliances are designed for use as

supplemental heater. They are not intended for continuous use

as a primary heat source.

•

•
•

©Lennox Industries Inc. 2009
Visit us at www.Lennox.com, or contact us at 1-800-9-LENNOX.

506033-28 05/09

WARNING

Baffle Plates

Proof of Fire Switch

Ash Clean-Out Ports

Exhaust Passages/Vent Pipe

and Creosote Removal

Gaskets

Cleaning Rear Stove Compart-

ment

•
•
•
•

•
•

Heat Exchanger

Keeping the heat exchanger

tubes clean will maximize the

heating efficiency of your stove.

Use the scraper tool to pull the

tube scraper rod back and forth

to release any ash build-up

inside the firebox.

2 Days - 2 Weeks*

2 Weeks - 2 Months*

Use the provided brush

to remove ash buildup

from the outside of the

heat exchanger tubes.