Directed Electronics rk20 Benutzerhandbuch

33

© 2008 Directed Electronics. All rights reserved.

Tachometer settings

➤

 Intelli-Tach

To program Intelli-Tach:

After the install is complete, remote start the car. 

1. 

If the car does not start on the first attempt, let the remote start attempt 

2. 

again.

Once the car starts, let it run until the parking lights come on.

3. 

When the parking lights come on, shut off the remote start with the remote 

4. 

- that's it! Intelli-Tach is programmed. 

To reset Intelli-Tach, go into the remote programming grid and choose option 

#4. Intelli-Tach cannot be reset with the ProSecurity Programmer.

Intelli-Tach handles disengaging the starter motor during remote starting – it does 

not address over-rev. If the customer wants to have the over-rev protection ca-

pability, now listed as optional in the owner’s guide, the tach wire must be con-

nected. This may involve more installation shop charges than initially quoted.

Important:  If  the  Intelli-Tach  mode  over  cranks  or  doesn't 

crank the vehicle long enough to start and run the car, use the  

ProSecurity Programmer to add or subtract the starter output 

time. You can adjust the output time in increments of 50mSec 

of the learned time using the ProSecurity Programmer.