Philips mcd290 Benutzerhandbuch
27
English
Radio Reception
DISPLAY/ST
2
T H E A T H R E
Tuning to radio stations
1
Press SOURCE on the set or TUNER on the
remote repeatedly until the desired waveband
(FM or MW) is displayed.
remote repeatedly until the desired waveband
(FM or MW) is displayed.
2
Press and hold TUNING
22/33 and release
the button.
➜
The radio automatically tunes to a station
with sufficient reception.
3
Repeat step 2 if necessary until you find the
desired station.
desired station.
●
To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.
22/33 briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 20 radio stations
for each band in the memory.
for each band in the memory.
Automatic programming
Press PROGRAM for more than three
seconds to activate programming.
seconds to activate programming.
➜
All available stations are programmed.
➜
AUTO is displayed and available stations are
programmed in order of waveband.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
radio stations”).
2
Press PROGRAM to activate programming.
➜
PROG flashes on the display.
3
Press PRESET
í/ë to allocate a number
from 1 to 20 to this station.
4
Press PROGRAM again to confirm the setting.
➜
PROG disappears.
5
Repeat the above four steps to store other
stations.
stations.
●
You can override a preset station by storing
another frequency in its place.
another frequency in its place.
Tuning to preset radio stations
●
Press PRESET
í/ë until the desired preset
station is displayed.
pg001-pg036_MCD290_98-Eng
2005.11.14, 14:50
27